Baffleplates for Ultimate Woodheaters

Late Model Ultimate Woodheaters

Ultimate normally make inbuilt and freestanding models of all their woodheaters. The baffleplates have an upward fold at the front and an airbar with holes in it at the back. Ultimates more recent woodheaters have a second airbar above the baffleplate which is only seen when the baffleplate is removed. These double airbar baffleplates are sometimes installed upsidedown. This is not a good idea.

The baffleplate rests in L-sections at the back and steel pins at the sides towards the front. The L-sections may have been bent forward at some time to make it easier to remove or replace the baffleplate. To remove the baffleplate, lift the back clear of the rear supports; move it forward clear of the rear supports and then lower the back so that the baffleplate comes off the front supports. The plate can then be maneuvered through the firedoor if it is not warped too much.

We make and normally stock baffleplates for most Ultimate Supreme, Elite and Ultima woodheaters. Our baffleplates use special materials and are reinforced to last longer than the manufacturers original product

We also repair Ultimate woodheaters

Other Ultimate Woodheaters

We make about 50 different baffleplates, so it is likely that we can supply you with a suitable baffleplate for your heater. Our baffleplate identification page may help you identify the plate you need. Should we not have a suitable baffleplate, then we have a limited special offer to supply one to your specification for a special price of $100

Normally our baffleplates are in stock and can be picked up or shipped promptly.


You are welcome to contact us for advice on woodheaters and baffleplates. 🕼