Baffleplates for Austwood Woodheaters

Model 250-450 Austwood 'HiTech' Woodheaters

Woodheaters in Austwood's Hi-Tech range have a rectangular baffleplate with an upward fold at the front and an airbar with holes in it at the back. The baffleplate rests in supports each side at the back and steel pins at the sides towards the front. The rear supports may have been bent flat at some time to make it easier to remove or replace the baffleplate. We make baffleplates for the compact, medium and large models in this range.

We also improve on the original Austwood designs by supplying a baffleplate extention; we believe this improves the heater efficiency getting more warmth from the firewood you burnt. With the extention installed the heater looks more like a top of the range heater inside. We can supply either our basic Austwood baffleplate or our improved version. Our extention is made of the same alloy as the baffleplate, so when they get hot they expand the same amount. Dont make your own from a different material.

Austwood Wentworth Woodheaters

The Wentworth series have a very basic cast iron baffleplate. We make baffleplates for the compact and medium models in this range. Our plates are reinforced for a longer life.

Austwood Omega Woodheaters

The Omega Series woodheaters had an airbar assembly across the back of the firebox and partway up the sides. The baffleplate rested on top of the airbar assembly and was not attached to it. There were 2 sections to the baffleplate.

We stock the Omega medium model baffleplate. We redesigned the join between the 2 baffleplate sections to improve on the original Austwood design.

We also make a replacement airbar assembly for this model. To install it you need to be able to use an angle grinder and a welder. We use heavier gauge metal than Austwood, so our kit should last well.

Other Austwood Woodheaters

We make about 50 different baffleplates, so it is likely that we can supply you with a suitable baffleplate for your heater. Click on the "Enquiry" link below so that we can help you identify a suitable plate for your heater.You can also contact us directly using the details on our home page.

Should we not have a suitable baffleplate, then we have a limited special offer to supply one to your specification for a bargain price

Normally our baffleplates are in stock and can be picked up or shipped promptly.

Enquiry. 🕼